DIAGNOSTIC TROUBLE CODE CHART
Meter / Gauge System
DTC No. |
Detection Item |
Memory |
Link |
---|---|---|---|
B1500 |
Fuel Sender Open Detected |
- |
|
B1507 |
Open in Turn Signal Circuit |
DTC stored |
|
B1508 |
Short in Turn Signal / Hazard Flasher Circuit |
DTC stored |
|
U0100 |
Lost Communication with ECM / PCM "A" |
DTC stored |
|
U0129 |
Lost Communication with Brake System Control Module |
DTC stored |
|
U0131 |
Lost Communication with Power Steering Control Module |
DTC stored |
|
U0142 |
Lost Communication with Body Control Module "B" |
DTC stored |
|
U0151 |
Lost Communication with Restraints Control Module |
DTC stored |
|
U0182 |
Lost Communication with Lighting Control Module Front |
DTC stored |
|
U0235 |
Lost Communication with Cruise Control Front Distance Range Sensor |
DTC stored |
|
U023A |
Lost Communication with Front Camera Module |
DTC stored |
|
Toyota CH-R Service Manual > Meter / Gauge System: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE METER / GAUGE SYSTEM
(a) Customizing with the Techstream.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Warning or Display.
(5) Select the setting by referr ...
Toyota CH-R Service Manual > Blind Spot Monitor System: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION
This DTC is stored when a beam axis adjustment has not been performed for the
blind spot monitor sensor LH (Master).
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose
of this DTC is to ensure that a beam axis adjustment is performed. Completi ...