Toyota CH-R Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.

(e) Check for DTCs.

Body Electrical > Combination Meter > Trouble Codes

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Clear DTCs.

(e) Clear the DTCs.

Body Electrical > Combination Meter > Clear DTCs
    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when decidi ...

    Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART Meter / Gauge System DTC No. Detection Item Memory Link B1500 Fuel Sender Open Detected ...

    Other materials:

    Toyota CH-R Service Manual > Tire Pressure Warning System: Initialization
    INITIALIZATION NOTICE: Initialization can be confirmed through the tire pressure warning light. If the ignition switch off during initialization, the tire pressure warning ECU and receiver memorizes that initialization was being performed. Therefore, it is not necessary to p ...

    Toyota CH-R Service Manual > Rear Stabilizer Bar: Installation
    INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER BUSHING (a) Install the 2 rear stabilizer bushings to the rear stabilizer bar. NOTICE: Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle. 2. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (a) Insta ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0162