Toyota CH-R Service Manual: Reassembly

NOTICE:

• When removing and installing the combination meter glass, make sure not to touch the display panel.
• Do not allow any dirt (fingerprints, grease, etc.) to adhere to the combination meter glass. If the glass is dirty, wipe it clean with a soft cloth.

Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

Installation

INSTALLATION PROCEDURE 1. INSTALL COMBINATION METER ASSEMBLY (a) Connect the 2 connectors to install the combination meter assembly. (b) Engage the guides and clips. ...

Other materials:

Toyota CH-R Service Manual > Tire Pressure Warning System: Transmitter ID1 Operation Stop (C2111/11-C2115/15)
DESCRIPTION The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressures. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured tire pres ...

Toyota CH-R Service Manual > Rear Wiper Motor: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR WIPER MOTOR ASSEMBLY (a) Operate the rear wiper motor assembly. *a Alignment Mark (b) Stop the ...