Toyota CH-R Service Manual: Relay

Inspection

INSPECTION

PROCEDURE

1. INSPECT SECURITY WARNING RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Connection

3 - 5

Battery voltage applied to terminal 1 and 2

Below 1 Ω

3 - 5

Battery voltage not applied to terminal 1 and 2

10 kΩ or higher

  • If the result is not as specified, replace the security warning relay.
    Security Indicator Light Does not Blink
    DESCRIPTION The transponder key ECU assembly blinks the security indicator light when the immobiliser is set. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the transponder key ECU assembl ...

    Security Horn Assembly
    Components COMPONENTS ILLUSTRATION *1 NO. 2 CYLINDER HEAD COVER *2 SECURITY HORN ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified ...

    Other materials:

    Toyota CH-R Service Manual > Safety Connect System: Short in Telephone Antenna Circuit (B1573,B15CB)
    DESCRIPTION These DTCs are stored when the DCM (Telematics Transceiver) detects an open or a short in the telephone and GPS antenna assembly (for Roof Side) circuit. The DCM (Telematics Transceiver) oscillates and receives 824 - 894 MHz or 1850 - 1990 MHz radio-frequency through the telephone ...

    Toyota CH-R Service Manual > Rear Combination Light Assembly(for Bulb Type): Components
    COMPONENTS ILLUSTRATION *1 REAR COMBINATION LIGHT ASSEMBLY *2 REAR COMBINATION LIGHT COVER *3 REAR COMBINATION LIGHT LED *4 REAR COMBINATION LIGHT SOCKET AND WIRE *5 REAR SID ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0089