REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the No. 1 cooler thermistor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced|
Replacement Part or Procedure |
Necessary Procedures |
Effects / Inoperative when not performed |
Link |
|---|---|---|---|
|
Disconnect cable from negative battery terminal |
Memorize steering angle neutral point |
Lane departure alert system (w/ Steering Control) |
|
|
Pre-collision system |
|||
|
Initialize back door lock |
Power door lock control system |
|
|
|
Initialize servo motor (Air conditioning system) |
DTCs are stored |
|
PROCEDURE
1. REMOVE BLOWER ASSEMBLY
Click here
2. REMOVE HEATER COVER (w/o PTC Heater)
Click here
3. REMOVE NO. 2 HEATER COVER (w/ PTC Heater)
Click here
4. REMOVE QUICK HEATER ASSEMBLY (w/ PTC Heater)
Click here
5. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
Click here
6. REMOVE AIR CONDITIONING HARNESS ASSEMBLY
Click here
7. REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
Click here
8. REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
Click here
9. REMOVE HEATER PIPE GROMMET
Click here
10. REMOVE HEATER CLAMP
Click here
11. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Click here
12. REMOVE COOLER EXPANSION VALVE
Click here
13. REMOVE HEAT EXCHANGER CASE
Click here
14. REMOVE RADIATOR CASE SUB-ASSEMBLY
Click here
15. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Click here
16. REMOVE NO. 1 COOLER THERMISTOR
|
(a) Remove the No. 1 cooler thermistor. |
|
Components
InspectionToyota CH-R Service Manual > Navigation System: XM Tuner Antenna Disconnected (B15FE,B15FF)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the roof antenna assembly
which is connected to the radio and display receiver assembly.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
B15FE
XM Tun ...
Toyota CH-R Service Manual > Lin Communication System: Driver Side Door ECU Communication Stop (B2321)
DESCRIPTION
This DTC is stored when LIN communication between the power window regulator
motor assembly (for driver door) and main body ECU (multiplex network body ECU)
stops for 10 seconds or more.
DTC No.
Detection Item
DTC Detection Condition
Trou ...