INSTALLATION
PROCEDURE
1. INSTALL COMBINATION METER ASSEMBLY
(a) Connect the 2 connectors to install the combination meter assembly.
|
(b) Engage the guides and clips. |
|
(c) Install the 2 screws.
2. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
Click here
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Click here
5. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Click here
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
Reassembly
Light Control RheostatToyota CH-R Service Manual > Blind Spot Monitor System: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION
This DTC is stored when a beam axis adjustment has not been performed for the
blind spot monitor sensor LH (Master).
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose
of this DTC is to ensure that a beam axis adjustment is performed. Completi ...
Toyota CH-R Service Manual > Lighting System: Diagnosis System
DIAGNOSIS SYSTEM
DESCRIPTION
(a) Lighting system data and Diagnostic Trouble Codes (DTCs) can be read from
the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning,
use the Techstream to check for malfunctions and perform repairs.
CHECK DLC3
(a) Check the D ...