Toyota CH-R Service Manual: Fail-safe Chart
FAIL-SAFE CHART
|
DTC |
Trouble Area |
Parking Brake Indicator Light (Red) |
Brake System Warning Light (Yellow) |
Fail-safe Deactivation Condition |
|---|---|---|---|---|
|
C13A5 |
Motor current monitor malfunction |
Normal |
Illuminates |
After returning to normal condition, turn ignition switch again |
|
C13A6 |
Motor open or short circuit malfunction |
Normal*1 |
Illuminates |
After returning to normal condition, turn ignition switch again |
|
C13A7 |
Actuator assembly malfunction (jamming, spinning, repeated slipping) |
Blinks |
Illuminates |
After returning to normal condition, Clear DTSs |
|
C13AA |
Electric parking brake high temperature |
Blinks |
Does not illuminate |
After 1 minute |
|
C13B0 |
ECU malfunction |
Normal (flashes when EEPROM malfunction occurs) |
Illuminates |
After returning to normal condition, turn ignition switch again |
|
C13B4 |
Electric parking brake switch open or short circuit malfunction |
Normal |
Illuminates |
After returning to normal condition, turn ignition switch again |
- *1: The parking brake indicator light blinks (red) if the electric parking brake switch assembly is pulled or pushed.
Freeze Frame Data
FREEZE FRAME DATA
FREEZE FRAME DATA
HINT:
When a DTC is stored, the freeze frame data stores the current vehicle
(sensor) state as.
The freeze frame data cannot be cleared or update ...
Data List / Active Test
DATA LIST / ACTIVE TEST
READ DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any ...
Other materials:
Toyota CH-R Service Manual > Occupant Classification System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Toyota CH-R Service Manual > Rocker Panel Moulding: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL ROCKER PANEL MOULDING PAD
HINT:
Using the same procedure, remove every rocker panel moulding pad.
When installing the rocker panel moulding pad, heat the rocker panel
moulding using a heat light.
Heating Temperature:
Item
...
Toyota CH-R Owners Manual
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Toyota CH-R Service Manual
- Introduction
- Maintenance
- Audio / Video
- Cellular Communication
- Navigation / Multi Info Display
- Park Assist / Monitoring
- Brake (front)
- Brake (rear)
- Brake Control / Dynamic Control Systems
- Brake System (other)
- Parking Brake
- Axle And Differential
- Drive Shaft / Propeller Shaft
- K114 Cvt
- 3zr-fae Battery / Charging
- Networking
- Power Distribution
- Power Assist Systems
- Steering Column
- Steering Gear / Linkage
- Alignment / Handling Diagnosis
- Front Suspension
- Rear Suspension
- Tire / Wheel
- Tire Pressure Monitoring
- Door / Hatch
- Exterior Panels / Trim
- Horn
- Lighting (ext)
- Mirror (ext)
- Window / Glass
- Wiper / Washer
- Door Lock
- Heating / Air Conditioning
- Interior Panels / Trim
- Lighting (int)
- Meter / Gauge / Display
- Mirror (int)
- Power Outlets (int)
- Pre-collision
- Seat
- Seat Belt
- Supplemental Restraint Systems
- Theft Deterrent / Keyless Entry
0.0093