Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT GLOVE BOX LIGHT ASSEMBLY

(a) Check that the LED illuminates.

(1) Apply battery voltage to the glove box light assembly and check that the LED illuminates.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → 2 (B)

Battery negative (-) → 1 (E)

LED illuminates

If the result is not as specified, replace the glove box light assembly.

*a

Component without harness connected (Glove Box Light Assembly)

    Removal
    REMOVAL PROCEDURE 1. REMOVE REAR CONSOLE BOX ASSEMBLY Click here 2. REMOVE FRONT DOOR SCUFF PLATE RH HINT: Use the same procedure as for the LH side. Click here 3. REMOVE COWL SIDE TRI ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL GLOVE BOX LIGHT ASSEMBLY (a) Turn the glove box light assembly as shown in the illustration and install it. Turn 2. INSTALL NO. ...

    Other materials:

    Toyota CH-R Service Manual > Airbag System: Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each sy ...

    Toyota CH-R Service Manual > Airbag System: Trouble in Passenger Airbag ON/OFF Indicator
    DESCRIPTION This circuit detects the airbag cut off switch cylinder sub-assembly status. The passenger airbag ON/OFF indicator comes on to inform the driver of the instrument panel passenger without door airbag assembly status (activated or deactivated). HINT: Approximately 6 seconds after the ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0083