INITIALIZATION
INITIALIZATION SERVO MOTOR
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Press the A/C OFF switch.
(e) Turn the Techstream on.
(f) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
(g) According to the Techstream display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility|
Tester Display |
|---|
|
Servomotor Initialization |
HINT:
During initialization, the AUTO indicator light comes on, and then goes off when initialization has finished.
(h) According to the Techstream display, select the Exit switch to finish initialization.
Customize Parameters
Problem Symptoms TableToyota CH-R Service Manual > Rear Seat Inner Belt Assembly(for Lh Side): Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (w/ Seat Belt Warning
System)
(a) for LH:
(1) Check the resistance.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
...
Toyota CH-R Service Manual > Lighting System: Operation Check
OPERATION CHECK
AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK
(a) Turn the ignition switch to ON.
(b) Turn the light control switch to the AUTO position.
(c) Cover the automatic light control sensor.
(d) Check that the taillights and low beam headlights come on.
(e) Uncover the automatic ligh ...