DATA LIST / ACTIVE TEST
DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Main Body > Data List
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|---|
Outer Mirror Fold SW |
Retractable outer mirror switch signal* |
OFF or ON |
OFF: Mirror retract switch not in retract position ON: Mirror retract switch in retract position |
- |
Auto Mirror SW |
Retractable outer mirror switch signal* |
OFF or ON |
OFF: Mirror retract switch not in auto position ON: Mirror retract switch in auto position |
- |
ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner or Main Body / Active Test.
(e) Perform the Active Test according to the display on the Techstream.
Body Electrical > Air Conditioner > Active Test
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
---|---|---|---|
Defogger Relay (Rear) |
Mirror heater operation |
OFF or ON |
- |
(f) Perform the Active Test according to the display on the Techstream.
Body Electrical > Main Body > Active Test
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
---|---|---|---|
Mirror Fold |
Retract mirror operation* |
OFF or ON |
- |
Mirror Return |
Retract mirror operation* |
OFF or ON |
- |
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Acceleration Sensor Circuit (P1585)
DESCRIPTION
The ECM determines the vehicle inclination based on a signal from the airbag
sensor assembly (yaw rate and acceleration sensor). If a malfunction in the airbag
sensor assembly (yaw rate and acceleration sensor) is determined based on a malfunction
signal from the skid control ECU ...
Toyota CH-R Service Manual > Horn System: Parts Location
PARTS LOCATION
ILLUSTRATION
*1
LOW PITCHED HORN ASSEMBLY
*2
HORN RELAY
*3
NO. 1 ENGINE ROOM RELAY BLOCK
*4
HORN FUSE
ILLUSTRATION
*1
SPIRAL CABLE SUB-ASSEMBLY
...