Toyota CH-R Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage with the ignition switch off.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, replace the battery.

    Terminals Of Ecu
    TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (w/ Retract Mirror) (a) Remove the main body ECU (multiplex network body ECU) from ...

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any part ...

    Other materials:

    Toyota CH-R Service Manual > Rear Combination Light Assembly(for Bulb Type): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR COMBINATION LIGHT ASSEMBLY (a) Connect the connector. (b) Engage the guide, pin and clip to temporarily instal ...

    Toyota CH-R Service Manual > Airbag System: Short in Front Passenger Side Squib Circuit (B1805/52-B1808/52)
    DESCRIPTION The front passenger side squib circuit consists of the airbag sensor assembly and instrument panel passenger without door airbag assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0074