CAUTION / NOTICE / HINT
HINT:
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK |
|
|
3. |
INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
|
4. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in Problem Symptoms Table. |
A |
|
Fault is listed in Problem Symptoms Table. |
B |
| B | |
GO TO PROBLEM SYMPTOMS TABLE
|
|
|
5. |
OVERALL ANALYSIS AND TROUBLESHOOTING |
(a) DATA LIST / ACTIVE TEST
Click here
(b) Terminals of ECU
Click here
(c) Inspection
(d) On-vehicle inspection
|
|
6. |
ADJUST, REPAIR OR REPLACE |
|
|
7. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
Operation CheckToyota CH-R Service Manual > Rear Bumper: Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR BUMPER ASSEMBLY
(a) Engage the claws as shown in the illustration.
Install in the Direction
(b) Engage the claws to install the rear bumper assembly as shown in the illustration.
HINT:
Use the same procedure for the RH side ...
Toyota CH-R Service Manual > Front Door Lock: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH (w/o Double Locking System)
(a) Check the door lock motor operation (for Driver Side).
(1) Apply battery voltage to the motor connector and check the operation
of the door lock motor.
OK:
...