REMOVAL
PROCEDURE
1. REMOVE REAR CONSOLE BOX ASSEMBLY
Click here
2. REMOVE FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
3. REMOVE COWL SIDE TRIM BOARD RH
HINT:
Use the same procedure as for the LH side.
Click here
4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Click here
6. REMOVE GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY
Click here
7. REMOVE NO. 2 INSTRUMENT PANEL LOWER FINISH PANEL
Click here
8. REMOVE GLOVE BOX LIGHT ASSEMBLY
(a) Turn the glove box light assembly as shown in the illustration and remove it.
|
Turn |
Components
InspectionToyota CH-R Service Manual > Electric Parking Brake Actuator: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY
(a) Apply a light coat of lithium soap base glycol grease to a new O-ring.
(b) Inst ...
Toyota CH-R Service Manual > Rear Axle Carrier: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
rear axle carrier sub-assembly removal/installation are shown below.
Necessary Procedures After ...