INSTALLATION
PROCEDURE
1. INSTALL PIPING CLAMP (for DENSO Made)
(a) for Suction Hose Sub-assembly:
(1) Remove the vinyl tape from the open ends of the suction pipe sub-assembly and suction hose sub-assembly.
|
(2) Install a new piping clamp to the suction hose sub-assembly. NOTICE:
|
|
(3) Thoroughly coat 2 new O-rings and contact surface of the suction hose sub-assembly with compressor oil.
Compressor Oil:
ND-OIL 12 or equivalent
(4) Install the 2 O-rings to the suction hose sub-assembly.
NOTICE:
Do not let foreign matter adhere to the O-rings or O-ring seals.
|
(5) Engage the suction pipe sub-assembly and suction hose sub-assembly by matching the alignment marks. NOTICE: Engage the parts by holding the pipe, not the piping clamp. |
|
|
(6) Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the suction pipe sub-assembly. HINT:
|
|
(b) for Cooler Refrigerant Liquid Pipe A:
Click here
2. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
Click here
Click here
3. WARM UP ENGINE
Click here
Click here
4. INSPECT FOR REFRIGERANT LEAK
Click here
Click here
RemovalToyota CH-R Service Manual > Meter / Gauge System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
When replacing the combination meter assembly, always replace it with a new one.
If a combination meter assembly which was installed to another vehicle is used,
the information stored in it will not match the information from the vehicle and
a DTC may be stored ...
Toyota CH-R Service Manual > Audio And Visual System(for Radio Receiver Type): Speaker Circuit
DESCRIPTION
If there is a short in a speaker circuit, the radio receiver assembly detects
it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction
in the radio receiver assembly or speakers.
WIRING DIAGRAM
PROCEDURE
1.
...