ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLER CONDENSER ASSEMBLY
(a) If the cooler condenser assembly fins are dirty, clean them with water and dry them with compressed air.
NOTICE:
Do not damage the cooler condenser assembly fins.
(b) If any cooler condenser assembly fins are bent, straighten them using a screwdriver or pliers.
2. INSPECT FOR REFRIGERANT LEAK
(a) Using a halogen leak detector, check the pipe joints for refrigerant leaks.
(b) If a refrigerant leak is detected in a joint, check the torque of the bolt of the joint.
Components
RemovalToyota CH-R Service Manual > Can Communication System: Main Body ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Main Body ECU Communication Stop Mode
Any of the following conditions are met:
Communication stop for "Main Body" is indicated on the "Communication
Bus Ch ...
Toyota CH-R Service Manual > Power Steering Ecu: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
power steering ECU assembly removal/installation are shown below.
Necessary Procedure After Par ...