Toyota CH-R Service Manual: Installation

Disassembly

DISASSEMBLY PROCEDURE 1. PRECAUTION NOTICE: Make sure to perform initialization after replacing the No. 1 blower damper servo sub-assembly. If initialization is not performed, the air conditione ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL BLOWER RESISTOR (for Single Type) (a) Engage the guides and install the blower resistor as shown in the illustration. Install in this Directio ...

Other materials:

Toyota CH-R Service Manual > Airbag System: SRS Warning Light does not Come ON
DESCRIPTION The SRS warning light is located in the combination meter assembly. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from off to ON, and then goes off automatically. If there is a malfunction in the SRS, the SRS w ...

Toyota CH-R Service Manual > Immobiliser System(w/ Smart Key System): Precaution
PRECAUTION PRECAUTIONS WHEN USING TECHSTREAM (a) When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then se ...