Toyota CH-R Service Manual: Problem Symptoms Table

HINT:

• Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
• Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Test Mode Procedure

TEST MODE PROCEDURE TEST MODE (SIGNAL CHECK MODE) PROCEDURE HINT: When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal ...

Terminals Of Ecu

TERMINALS OF ECU CHECK TIRE PRESSURE WARNING ECU AND RECEIVER (a) Disconnect the M23 tire pressure warning ECU and receiver connector and measure the voltage or resistance on the wire harness side ...

Other materials:

Toyota CH-R Service Manual > How To Troubleshoot Ecu Controlled Systems: Electronic Circuit Inspection Procedure
ELECTRONIC CIRCUIT INSPECTION PROCEDURE BASIC INSPECTION (a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS (1) Unless otherwise stated, all resistance measurements are standard values measured at an ambient temperature of 20°C (68°F). Resistance measurements may be inaccurate if measured at ...

Toyota CH-R Service Manual > Theft Deterrent System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use this procedure to troubleshoot the theft deterrent system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. ...