INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
Take extra care when handling these precision electronic components.
PROCEDURE
1. INSTALL TRANSMITTER BATTERY
(a) Install a new transmitter battery with the positive (+) side facing upward, as shown in the illustration.
NOTICE:
![]() |
Install in this Direction |
(b) Install the transmitter housing cover by pressing down on it as shown in the illustration.
![]() |
Install in this Direction |
(c) Insert the mechanical key into the transmitter as shown in the illustration.
![]() |
Install in this Direction |
(d) Press one of the transmitter switches and check that the LED illuminates.
OK:
Transmitter LED illuminates when a switch is pressed.
Toyota CH-R Service Manual > Air Conditioning Pressure Sensor: Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONER PRESSURE SENSOR (for VALEO Made)
(a) Remove the vinyl tape from the cooler refrigerant liquid pipe A.
(b) Sufficiently apply compressor oil to a new air conditioner pressure sensor
and the fitting surface of the air conditioner pressure sensor. ...
Toyota CH-R Service Manual > Power Steering System: TC and CG Terminal Circuit
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the ECU to display DTCs by
blinking the EPS warning light.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
If the power steering ECU assembly has been replaced, perform assist map writing
and torque sensor zero point calibration ...