INSPECTION
PROCEDURE
1. INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Check that the LED illuminates.
|
(1) Apply battery voltage to the multiplex network master switch assembly and check that the LED illuminates. OK:
If the result is not as specified, replace the multiplex network master switch assembly. |
|
2. INSPECT DOOR CONTROL SWITCH ASSEMBLY
(a) Check the operation of the door control switch assembly.
|
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the door control switch assembly. |
|
(b) Check that the LED illuminates.
|
(1) Apply battery voltage to the multiplex network master switch assembly and check that the LED illuminates. OK:
If the result is not as specified, replace the door control switch assembly. |
|
Components
RemovalToyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Top-mounted
Air Conditioner Pressure Sensor): System Description
SYSTEM DESCRIPTION
GENERAL
The air conditioning system has the following controls.
Control
Outline
Neural Network Control
This control is capable of performing complex control by artificially
simulating the information processing method of the ...
Toyota CH-R Service Manual > Rear Suspension: Rear Upper Arm
Components
COMPONENTS
ILLUSTRATION
*1
REAR SUSPENSION MEMBER SUB-ASSEMBLY
*2
REAR UPPER CONTROL ARM ASSEMBLY LH
*3
REAR UPPER CONTROL ARM ASSEMBLY RH
-
-
Tightening torque f ...