Toyota CH-R Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the occupant detection ECU.

PROCEDURE

1. INSPECT OCCUPANT DETECTION ECU (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check.

Click here

2. INSPECT OCCUPANT DETECTION ECU (for Vehicle Involved in Collision)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the occupant detection ECU.

HINT:

The defects are as follows:

  • Cracks in the ECU housing
  • Dents in the ECU housing
  • Chips in the ECU housing
  • Cracks or other damage to the connector
  • Damage to the serial number

OK:

No defects are found.

If any defects are found, replace the occupant detection ECU with a new one.

    Components
    COMPONENTS ILLUSTRATION *1 OCCUPANT DETECTION ECU - - ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: VSC OFF Switch Circuit
    DESCRIPTION The skid control ECU assembly is connected to the combination meter assembly via CAN communication. Pressing the VSC OFF switch turns off TRAC operation, and pressing and holding this switch turns off TRAC and VSC operation. If TRAC and VSC operations are turned off, the TRAC OFF ...

    Toyota CH-R Service Manual > Shift Lever: Installation
    INSTALLATION PROCEDURE 1. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY (a) Temporarily install the floor shift shift lever assembly to the body with the 4 bolts. (b) Fully tighten the 4 bolts in the order shown in the illustration. Torque: 12 N·m {122 kgf·cm, 9 ft·lbf} (c) Engage the 6 cl ...

    © 2017-2020 Copyright www.tochr.net
    0.0153