Toyota CH-R Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

Click here

2. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Click here

3. REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY

Click here

4. REMOVE BACK DOOR SIDE GARNISH LH

Click here

5. REMOVE BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.

6. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

Click here

7. REMOVE BACK DOOR LOCK COVER

Click here

8. REMOVE BACK DOOR LOCK ASSEMBLY

(a) Disconnect the connector.

(b) Remove the 3 bolts and back door lock assembly.

    Inspection
    INSPECTION PROCEDURE 1. INSPECT BACK DOOR LOCK ASSEMBLY (a) Check the operation of the door lock motor. (1) Move the door lock to the close (lock) position. ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL BACK DOOR LOCK ASSEMBLY HINT: Make sure to remove the string before installing a new back door lock assembly. (a) Apply MP grease to the sliding parts of the bac ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: VSC does not Operate or VSC does not Operate Correctly
    DESCRIPTION When ABS, TRAC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred. When a communication malfunction with the ECM is detected, TRAC and VSC are disabled. Also, TRAC and VSC are disabled when ...

    Toyota CH-R Service Manual > Pre-collision System: Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each sy ...

    © 2017-2021 Copyright www.tochr.net
    0.0168