INSPECTION
PROCEDURE
1. INSPECT BACK DOOR LOCK ASSEMBLY
(a) Check the operation of the door lock motor.
|
(1) Move the door lock to the close (lock) position. |
|
(2) Apply battery voltage and check the operation of the door lock motor.
OK:
|
Battery Connection |
Result |
|---|---|
|
Battery positive (+) → Terminal 1 (ACT+) Battery negative (-) → Terminal 2 (ACT-) |
Back door lock motor open (unlock) operation |
If the result is not as specified, replace the back door lock assembly.
(b) Check the operation of the back door courtesy switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
2 (ACT-) - 3 (D+) |
Closed (Locked) |
10 kΩ or higher |
|
2 (ACT-) - 3 (D+) |
Open (Unlocked) |
Below 1 Ω |
If the result is not as specified, replace the back door lock assembly.
Components
RemovalToyota CH-R Service Manual > Steering Lock System: Terminals Of Ecu
TERMINALS OF ECU
TERMINAL INSPECTION
*a
Component without harness connected
(Steering Lock ECU (Steering Lock Actuator or Upper Bracket Assembly))
-
-
(a) Measure the voltage and resistance according to the value(s) in the table
below.
...
Toyota CH-R Service Manual > Rear Suspension System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspected Area" column of the table. Check each symptom by
check ...