INSTALLATION
PROCEDURE
1. INSTALL BACK DOOR LOCK ASSEMBLY
HINT:
Make sure to remove the string before installing a new back door lock assembly.
(a) Apply MP grease to the sliding parts of the back door lock assembly.
(b) Install the back door lock assembly with the 3 bolts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(c) Connect the connector.
2. INSTALL BACK DOOR LOCK COVER
Click here
3. INSTALL BACK DOOR TRIM PANEL ASSEMBLY
Click here
4. INSTALL BACK DOOR SIDE GARNISH LH
Click here
5. INSTALL BACK DOOR SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
6. INSTALL BACK DOOR TRIM UPPER PANEL ASSEMBLY
Click here
7. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Click here
8. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)
Click here
Removal
Door Control ReceiverToyota CH-R Service Manual > Wireless Door Lock Control System(w/o Smart Key System): Registration
REGISTRATION
CAUTION / NOTICE / HINT
HINT:
Register a new recognition code when replacing the door control transmitter
assembly or the door control and tire pressure monitoring system receiver
assembly.
Add mode is used to retain the codes that have already been registered
...
Toyota CH-R Owners Manual > Dynamic radar cruise control with full-speed range: Changing the vehicle-to-vehicle distance (vehicle-to-vehicle distance
control mode)
Pressing the switch changes the vehicle-to-vehicle distance as follows:
Long
Medium
Short
The vehicle-to-vehicle distance is set automatically to long mode when the engine
switch is turned to the "ON" position (vehicles without a smart key system) or IGNITION
ON mode (vehicl ...