FAIL-SAFE CHART
RAIN SENSOR FAIL-SAFE FUNCTION
(a) The windshield wiper switch assembly performs the fail-safe function when the wiper system cannot properly receive the necessary signals for wiper system control or a wiper system component is malfunctioning.
Item |
Fail-safe Function |
Conditions to Return to Normal Condition |
---|---|---|
Rain sensor LIN communication error |
Continues control according to the conditions detected before the malfunction |
LIN communication returns to normal. |
Rain sensor voltage is too low |
Rain sensor voltage returns to normal. |
|
Abnormal rain sensor signal |
Performs intermittent operation according to the position of the auto sensitivity adjustment switch. |
The rain sensor returns to normal. |
The rain sensor temperature is too high (90°C (194°F) or higher). |
Stops the wiper operation |
|
The rain sensor temperature is too low (-15°C (5°F) or lower). |
Toyota CH-R Service Manual > Occupant Classification Ecu: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
occupant detection ECU removal/installation are shown below.
Necessary Procedure After Parts Re ...
Toyota CH-R Service Manual > Vehicle Stability Control System: Yaw Rate Sensor (C1234,C1472,C1474)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the yaw
rate and acceleration sensor (airbag sensor assembly) via CAN communication.
HINT:
If there is a malfunction in the bus lines between the yaw rate and acceleration
sensor (airbag sensor assembly) and the ...