PRECAUTION
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK |
Off (Lock) |
|
Ignition Switch ACC |
ACC |
On (ACC) |
|
Ignition Switch ON |
ON |
On (IG) |
|
Engine Start |
START |
On (Start) |
HANDLING PRECAUTIONS FOR FORWARD RECOGNITION CAMERA
(a) The automatic high beam system uses the forward recognition camera. For precautions related to the forward recognition camera, refer to Precaution for Forward Recognition Camera System.
Click here
PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY
(a) When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Parts LocationToyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Engine does not Start but Initial Combustion Occurs
DESCRIPTION
If the key ID codes of the key and transponder key ECU assembly match, the immobiliser
system is unset and the engine start permission signal is sent to the ECM. When
the ID codes of the transponder key ECU assembly and ECM match, the engine starts.
WIRING DIAGRAM
CAUTION / NOTI ...
Toyota CH-R Service Manual > Can Communication System: Check Bus 5 Line for Short to +B
DESCRIPTION
There may be a short circuit between one of the CAN bus lines and +B when no
resistance exists between terminal 15 (CA5H) of the central gateway ECU (network
gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 16 (CA5L) of the central
gateway ECU (network gateway ECU) and ...