REMOVAL
PROCEDURE
1. REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY
Click here
2. REMOVE BACK DOOR SIDE GARNISH LH
Click here
3. REMOVE BACK DOOR SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
4. REMOVE BACK DOOR TRIM PANEL ASSEMBLY
Click here
5. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
(a) Slide the rear wiper arm head cap as shown in the illustration to disengage the 2 claws. |
|
(b) Disengage the claws and guides to remove the rear wiper arm head cap as shown in the illustration.
![]() |
Remove in this Direction (1) |
![]() |
Remove in this Direction (2) |
(c) Remove the nut and rear wiper arm and blade assembly. |
|
6. REMOVE REAR WIPER MOTOR GROMMET
(a) Remove the rear wiper motor grommet. |
|
7. REMOVE REAR WIPER MOTOR ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the 2 bolts.
(c) Loosen the bolt to remove the rear wiper motor assembly.
HINT:
Remove the bolt and rear wiper motor assembly as a set.
Toyota CH-R Service Manual > Windshield Deicer System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the windshield deicer system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Toyota CH-R Service Manual > Blind Spot Monitor System: Software Incompatibility with Body Control Module "B" (U1331)
DESCRIPTION
This DTC is stored when the destination information of the main body ECU (multiplex
network body ECU) does not match that of the blind spot monitor sensors.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
U1331
...