ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REAR WIPER MOTOR ASSEMBLY
|
(a) Operate the rear wiper motor assembly. |
|
(b) Stop the rear wiper motor assembly operation.
(c) Check the automatic stop position.
HINT:
After the rear wiper motor is stopped, check the automatic stop position after lifting the wiper blade 2 times.
Standard Clearance:
|
Area |
Measurement |
|---|---|
|
A |
10.0 mm (0.394 in.) |
OK:
The rear wiper stops at the position shown in the illustration.
Components
RemovalToyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted
Air Conditioner Pressure Sensor): Blower Motor Circuit
DESCRIPTION
The blower motor with fan sub-assembly is operated by signals from the air conditioning
amplifier assembly. Blower motor speed signals are transmitted in accordance with
changes in the duty ratio.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits re ...
Toyota CH-R Service Manual > Immobiliser System(w/ Smart Key System): Precaution
PRECAUTION
PRECAUTIONS WHEN USING TECHSTREAM
(a) When using the Techstream with the engine switch off, connect the Techstream
to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds
or less until communication between the Techstream and the vehicle begins. Then
se ...