INSPECTION
PROCEDURE
1. INSPECT REAR WIPER MOTOR ASSEMBLY
|
*a |
Component without harness connected (Rear Wiper Motor Assembly) |
(a) Check that the rear wiper motor assembly operates.
NOTICE:
Check that the body ground is connected.
(1) Apply battery voltage to the rear wiper motor connector and check the speed of the rear wiper motor assembly.
OK:
|
Measurement Condition |
Specified Condition |
|---|---|
|
Battery positive (+) → Terminal 4 (+B) Battery negative (-) → Terminal 3 (LS) Battery negative (-) → Terminal 5 (E) |
Motor operates |
If the result is not as specified, replace the rear wiper motor assembly.
|
(b) Check the wiper intermittent operation. NOTICE: Check that the body ground is connected. (1) Apply battery voltage to the rear wiper motor connector and check the speed of the rear wiper motor assembly. OK:
If the result is not as specified, replace the rear wiper motor assembly. |
|
Removal
InstallationToyota CH-R Service Manual > Smart Key System(for Entry Function): Terminals Of Ecu
TERMINALS OF ECU
CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Disconnect the F1 certification ECU (smart key ECU assembly) connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the conne ...
Toyota CH-R Service Manual > Pre-collision System: Parts Location
PARTS LOCATION
ILLUSTRATION
*1
FRONT SPEED SENSOR RH
*2
FRONT SPEED SENSOR LH
*3
REAR SKID CONTROL SENSOR RH
*4
REAR SKID CONTROL SENSOR LH
ILLUSTRATION
*1
BRAKE ACTUA ...