Toyota CH-R Service Manual: System Description

SYSTEM DESCRIPTION

GENERAL

(a) This system has a rear television camera assembly mounted on the back door to assist the driver in parking the vehicle by displaying an image of the area behind the vehicle. The system displays the image on the multi-display.

(b) This system consists of the following components:

(1) Rear television camera assembly

(2) Radio and display receiver assembly

(3) Park/neutral position switch

FUNCTION OF COMPONENTS

(a) The radio and display receiver assembly controls the system by using information from the following components:

Components

Function

Rear Television Camera Assembly

  • Captures the view behind the vehicle and transmits the image to the radio and display receiver assembly.
  • Has a color video camera that uses a Complementary Metal Oxide Semiconductor (CMOS) and wide-angle lens.

Radio and Display Receiver Assembly

  • Receives the video signals which contain an image of the area behind the vehicle taken with the rear television camera assembly.
  • Performs control of the system by receiving the reverse signal from the BKUP LP relay.

Park/Neutral Position Switch

Receives the reverse signal from the park/neutral position switch and transmits it to the radio and display receiver assembly.

OPERATION EXPLANATION

(a) The radio and display receiver assembly receives the reverse signal when the ignition switch is turned to ON and the shift lever is moved to R. After receiving the reverse signal, the radio and display receiver assembly switches to the rear view monitor system.

HINT:

When the shift lever is moved to any position except R, the display turns off.

    System Diagram
    SYSTEM DIAGRAM ...

    How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the rear view monitor system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROU ...

    Other materials:

    Toyota CH-R Service Manual > Blower Unit(for Valeo Made): Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL BLOWER RESISTOR (for Single Type) (a) Engage the guides and install the blower resistor as shown in the illustration. Install in this Direction 2. INSTALL AIR FILTER SUB-ASSEMBLY (for Single Type) (a) Engage the guides t ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: TRAC does not Operate
    DESCRIPTION When ABS, TRAC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred. When in VSC off mode, or TRAC and VSC are disabled, the multi-information display in the combination meter assembly displa ...

    © 2017-2020 Copyright www.tochr.net
    0.0245