DATA LIST / ACTIVE TEST
DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Combination Meter / Data List.
(f) According to the display on the Techstream, read the Data List.
Body Electrical > Combination Meter > Data List|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Washer Switch |
Level warning switch condition |
ON/OFF |
ON: Fluid volume is less than 600 to 800 cc (36.6 to 48.8 cu.in.) OFF: Fluid volume is more than 600 to 800 cc (36.6 to 48.8 cu.in.) |
w/ Washer Fluid Warning System |
Fail-safe Chart
Wiper EcuToyota CH-R Service Manual > Exterior Panels / Trim: Wheel Opening Moulding(for Front)
Components
COMPONENTS
ILLUSTRATION
*1
FRONT FENDER MOULDING SUB-ASSEMBLY
-
-
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
...
Toyota CH-R Service Manual > Toyota Entune System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
The following may occur if a radio and display receiver assembly from
another vehicle is installed to this vehicle. Therefore, when replacing
the radio and display receiver assembly, be sure to replace it with a new
one.
A communicat ...