Components
COMPONENTS
ILLUSTRATION
|
*1 |
WINDSHIELD WIPER RELAY ASSEMBLY |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the windshield wiper relay assembly removal/installation are shown below.
Necessary Procedures after parts removed/installed/replaced|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Disconnect cable from negative battery terminal |
Initialize back door lock |
Power door lock control system |
|
|
Memorize steering angle neutral point |
Lane departure alert system (w/ Steering Control) |
|
|
|
Pre-collision system |
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
2. REMOVE WINDSHIELD WIPER RELAY ASSEMBLY
|
(a) Disconnect the connector. |
|
(b) Remove the bolt.
(c) Disengage the guide to remove the windshield wiper relay assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WIPER RELAY ASSEMBLY
|
(a) Engage the guide and install the windshield wiper relay assembly with the bolt. Torque: 12.5 N·m {127 kgf·cm, 9 ft·lbf} |
|
(b) Connect the connector.
2. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
Data List / Active Test
Wiper SwitchToyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Noise Occurs
PROCEDURE
1.
CHECK NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear
left or right).
OK:
The location of the noise source can be determined.
NG
GO TO STEP 3
OK
...
Toyota CH-R Service Manual > Back Door Lock: Components
COMPONENTS
ILLUSTRATION
*A
w/ Package Tray Trim
*B
w/ Tonneau Cover
*1
BACK DOOR LOCK ASSEMBLY
*2
BACK DOOR LOCK COVER
*3
BACK DOOR SIDE GARNISH LH
*4
B ...