INSTALLATION
PROCEDURE
1. INSTALL LEVEL WARNING SWITCH ASSEMBLY
(a) Install the level warning switch assembly as shown in the illustration.
|
Install in this Direction |
(b) Connect the connector.
2. ADD WASHER FLUID
Click here
3. INSTALL FRONT FENDER LINER RH
Click here
4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Click here
5. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH
Click here
6. INSTALL ROCKER PANEL MOULDING RH
Click here
7. INSTALL FRONT WHEEL RH
Click here
Inspection
Washer MotorToyota CH-R Service Manual > Power Window Control System: Terminals Of Ecu
TERMINALS OF ECU
CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the J6 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the connector ...
Toyota CH-R Service Manual > Navigation System: Sending Malfunction (Navigation to APGS) (U0073,U0100,U0129,U0140,U0155,U0164,U0198)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
U0073
Sending Malfunction (Navigation to APGS)
CAN bus connec ...