INSPECTION
PROCEDURE
1. INSPECT LEVEL WARNING SWITCH ASSEMBLY
HINT:
This check should be performed with the level warning switch assembly installed on the washer jar.
|
(a) Fill the washer jar with washer fluid. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
1 (S) - 2 (E) |
Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or higher* |
10 kΩ or higher |
|
Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or lower* |
Below 1 Ω |
HINT:
*: The level warning switch assembly begins operating when the fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) depending on the vehicle condition.
If the result is not as specified, replace the level warning switch assembly.
Removal
InstallationToyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Engine does not Start but Initial Combustion Occurs
DESCRIPTION
If the key ID codes of the key and transponder key ECU assembly match, the immobiliser
system is unset and the engine start permission signal is sent to the ECM. When
the ID codes of the transponder key ECU assembly and ECM match, the engine starts.
WIRING DIAGRAM
CAUTION / NOTI ...
Toyota CH-R Service Manual > Front Drive Shaft Assembly: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT DRIVE SHAFT ASSEMBLY
(a) Check that there is no excessive play in the radial direction of
the outboard joint.
(b) Check that the inboard joint slides smoothly in the thrust direction.
(c) Check ...