REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL RH
Click here
2. REMOVE ROCKER PANEL MOULDING RH
Click here
3. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH
Click here
4. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here
5. REMOVE FRONT FENDER LINER RH
Click here
6. DRAIN WASHER FLUID
Click here
7. REMOVE LEVEL WARNING SWITCH ASSEMBLY
(a) Disconnect the connector.
![]() |
Remove in this Direction |
(b) Remove the level warning switch assembly as shown in the illustration.
Toyota CH-R Service Manual > Brake Pedal: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
brake pedal support assembly removal/installation are shown below.
Necessary Procedures After P ...
Toyota CH-R Service Manual > Continuously Variable Transaxle Assembly(when Using The Engine Support Bridge): Components
COMPONENTS
ILLUSTRATION
*1
NO. 1 ENGINE UNDER COVER
*2
REAR ENGINE UNDER COVER LH
*3
REAR ENGINE UNDER COVER RH
-
-
N*m (kgf*cm, ft.*lbf): Specified torque
-
...