ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
(a) for LH Side:
|
(1) Operate the windshield wiper motor assembly. |
|
(2) Stop the windshield wiper motor assembly operation.
(3) Check the automatic stop (park) position.
HINT:
After the front wiper motor is stopped, check the automatic stop position after lifting the wiper blade 2 times.
Standard Clearance:
|
Area |
Measurement |
|---|---|
|
A |
7.5 mm (0.295 in.) |
OK:
The front wiper stops at the position shown in the illustration.
(b) for RH Side:
|
(1) Operate the windshield wiper motor assembly. |
|
(2) Stop the windshield wiper motor assembly operation.
(3) Check the automatic stop (park) position.
HINT:
After the front wiper motor is stopped, check the automatic stop position after lifting the wiper blade 2 times.
Standard Clearance:
|
Area |
Measurement |
|---|---|
|
A |
7.5 mm (0.295 in.) |
OK:
The front wiper stops at the position shown in the illustration.
Components
RemovalToyota CH-R Service Manual > Continuously Variable Transaxle System: Check Mode Procedure
CHECK MODE PROCEDURE
DESCRIPTION
(a) Check mode has a higher sensitivity to malfunctions and can detect malfunctions
that cannot be detected in normal mode. Check mode can also detect all the malfunctions
that can be detected in normal mode. In check mode, DTCs are stored with 1 trip
detecti ...
Toyota CH-R Owners Manual > Engine compartment: Washer fluid
Add washer fluid in the following situations:
A washer does not work.
The warning message appears on the multi-information display (if equipped).
The washer fluid level is extremely low (type A) or at "LOW" (type B).
Type A
Raise the cap keeping your finger pressed down ...