Toyota CH-R Service Manual: All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter

Wireless Transmitter-linked Function

• w/ Smart Key System:
  • When an electronic key transmitter sub-assembly switch is pushed: 1) the door control receiver receives the wireless door lock signal; 2) the door control receiver sends a signal to the main body ECU (multiplex network body ECU) through the certification ECU (smart key ECU assembly); 3) the main body ECU (multiplex network body ECU) sends the operation permission signal to the power window regulator motor assemblies; and 4) the power window regulator motor assemblies are activated.
• w/o Smart Key System:
  • When a key switch is pushed: 1) a door control receiver receives the wireless door lock signal; 2) the door control receiver sends a signal to the main body ECU (multiplex network body ECU); 3) the main body ECU (multiplex network body ECU) sends the operation permission signal to the power window regulator motor assembly ; and 4) the power window regulator motor assembly are activated.

Key-linked Function

• When the driver door key cylinder (key linked switch) is turned and held: 1) the door lock motor receives the signal; 2) the main body ECU (multiplex network body ECU) sends the signal to the power window regulator motor assemblies; and 3) the power window regulator motor assemblies are activated.

NOTICE:

• These functions are set through customize settings, as they are off by default.
• The power window control system uses the LIN communication system and CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication systems are functioning properly.

  Click here

• Check that power window system customize setting "Door Key P/W Up", "Door Key P/W Down" and "P/W Down W/Transmit" are set to "ON" before performing the following procedure.

  Click here

• If the main body ECU (multiplex network body ECU) is replaced, refer to Registration.*1

  Click here

  • *1: w/ Smart Key System

• w/ Smart Key System:

  Click here

• w/o Smart Key System:

  Click here

Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH

DESCRIPTION If the manual up and down functions operate normally but the auto up and down functions do not, the power window control system may be in fail-safe mode. If power window initialization ...

Key-off Operation Function Operates even if Operating Conditions are not Satisfied

DESCRIPTION When the front doors are closed, each power window regulator motor assembly can be operated for approximately 45 seconds after the ignition switch is turned from ON to off by receivin ...

Other materials:

Toyota CH-R Service Manual > Charging System: Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes. (e) Check for DTCs, and then write them down. Powertrain > Engine and ECT > Tro ...

Toyota CH-R Service Manual > Immobiliser System(w/ Smart Key System): Engine Starter Communication Malfunction (B2779)
DESCRIPTION If the remote engine start ECU does not respond to the certification ECU (smart key ECU assembly) or the remote engine start ID is not registered, this DTC is stored. HINT: Registration status of the remote engine start ECU ID can be checked using the "Wireless C Code" i ...