COMPONENTS
ILLUSTRATION
|
*1 |
REAR SEAT CENTER HEADREST ASSEMBLY |
*2 |
REAR SEAT HEADREST ASSEMBLY |
|
*3 |
REAR SEATBACK ASSEMBLY RH |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
- |
- |
ILLUSTRATION
|
*A |
TYPE A |
*B |
TYPE B |
|
*1 |
REAR CENTER SEAT OUTER BELT ASSEMBLY |
*2 |
REAR SEAT CENTER HEADREST ASSEMBLY |
|
*3 |
REAR SEAT HEADREST SUPPORT |
*4 |
REAR SEAT SHOULDER BELT HOLE COVER |
|
*5 |
REAR SEATBACK BOARD SUB-ASSEMBLY RH |
*6 |
REAR SEATBACK LOCK CONTROL BEZEL |
|
*7 |
SEAT BELT ANCHOR COVER CAP |
*8 |
SEPARATE TYPE REAR SEATBACK COVER WITH PAD |
|
*9 |
REAR SEATBACK FRAME SUB-ASSEMBLY RH |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
On-vehicle InspectionToyota CH-R Service Manual > Front Bumper: Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT BUMPER ASSEMBLY
(a) Move the front bumper assembly into position.
(b) w/ Toyota Safety Sense:
(1) Connect the connector.
(c) Temporarily install the front bumper assembly with the claw as shown in the
illustration.
Install in thi ...
Toyota CH-R Service Manual > Power Steering System: Terminals Of Ecu
TERMINALS OF ECU
CHECK POWER STEERING ECU ASSEMBLY
*a
Component without harness connected
(Power Steering ECU Assembly)
-
-
(a) Measure the voltage and resistance according to the value(s) in the table
below.
NOTICE:
When the EPS warni ...