Toyota CH-R Service Manual: On-vehicle Inspection

Toyota CH-R Service Manual / Seat Belt / Rear Center Seat Outer Belt Assembly / On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the rear center seat outer belt assembly.

PROCEDURE

1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)

(a) Visually check for defects with the rear center seat outer belt assembly installed to the vehicle.

(1) The defects to be checked are as follows:

Cuts on the rear center seat outer belt assembly
Small cracks on the rear center seat outer belt assembly
Significant discoloration on the rear center seat outer belt assembly

OK:

No defects are found.

HINT:

If any defects are found, replace the rear center seat outer belt assembly with a new one.

2. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)

(a) Visually check for defects with the rear center seat outer belt assembly removed from the vehicle.

(1) The defects to be checked are as follows:

Cuts on the rear center seat outer belt assembly
Small cracks on the rear center seat outer belt assembly
Significant discoloration on the rear center seat outer belt assembly
Cracks or other damage on the connector

OK:

No defects are found.

HINT:

If any defects are found, replace the rear center seat outer belt assembly with a new one.

Components

COMPONENTS ILLUSTRATION *1 REAR SEAT CENTER HEADREST ASSEMBLY *2 REAR SEAT HEADREST ASSEMBLY *3 REAR SEATBACK ASSEMBLY RH ...

Removal

REMOVAL PROCEDURE 1. REMOVE REAR SEAT HEADREST ASSEMBLY Click here 2. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY Click here 3. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY Click here 4 ...

Other materials:

Toyota CH-R Service Manual > Toyota Entune System: Precaution
PRECAUTION IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine ...

Toyota CH-R Service Manual > Front Brake: Reassembly
REASSEMBLY PROCEDURE 1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG (a) Temporarily install the front disc brake bleeder plug to the front disc brake cylinder assembly. HINT: Fully tighten the front disc brake bleeder plug after bleeding the system. 2. INSTALL FRONT DISC BRAKE BLEEDER ...

Toyota CH-R Service Manual: On-vehicle Inspection

Components

Removal

Other materials:

Toyota CH-R Owners Manual

Toyota CH-R Service Manual