REMOVAL
PROCEDURE
1. REMOVE REAR SEAT HEADREST ASSEMBLY
Click here
2. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY
Click here
3. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
Click here
4. REMOVE REAR SEATBACK ASSEMBLY RH
Click here
5. REMOVE SEAT BELT ANCHOR COVER CAP
Click here
6. REMOVE REAR SEAT SHOULDER BELT HOLE COVER
Click here
7. REMOVE REAR SEATBACK LOCK CONTROL BEZEL
Click here
8. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH
Click here
9. REMOVE REAR SEAT HEADREST SUPPORT
Click here
10. REMOVE REAR SEAT CENTER HEADREST SUPPORT
Click here
11. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD
Click here
12. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY
(a) Remove the nut. |
|
(b) Disengage the guides to remove rear center seat outer belt assembly.
Toyota CH-R Service Manual > Automatic High Beam System: Precaution
PRECAUTION
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine Swi ...
Toyota CH-R Service Manual > Revolution Sensor: Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSMISSION REVOLUTION SENSOR (NT)
(a) Apply Toyota Genuine CVT fluid FE to a new O-ring.
(b) Install the O-ring to the transmission revolution sensor (NT).
(c) Install the transmission revolution sensor (NT) to the continuously variable
transaxle assembly w ...