INSPECTION
PROCEDURE
1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY
|
(a) Before installing the rear center seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is between 0° and 20°, check that the belt can be pulled from the retractor. When the inclination of the retractor is less 0° or more than 20°, check that the belt locks. If the result is not as specified, replace the rear center seat outer belt assembly. |
|
Removal
InstallationToyota CH-R Service Manual > Seat Belt Warning System(w/ Occupant Classification System): System Diagram
SYSTEM DIAGRAM
FRONT SEAT BELT WARNING
Communication Table
Sender
Receiver
Signal
Communication Method
Airbag sensor assembly
Combination meter assembly
Front seat inner belt assembly LH buckle switch ...
Toyota CH-R Service Manual > Rear Door Courtesy Switch: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Using a T30 "TORX" socket wrench, install the rear door cou ...