INSTALLATION
PROCEDURE
1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY
Click here
2. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY
(a) Engage the guides to install the rear center seat outer belt assembly. |
|
(b) Install the nut.
Torque:
42 N·m {428 kgf·cm, 31 ft·lbf}
3. INSTALL SEPARATE TYPE REAR SEATBACK COVER WITH PAD
Click here
4. INSTALL REAR SEAT CENTER HEADREST SUPPORT
Click here
5. INSTALL REAR SEAT HEADREST SUPPORT
Click here
6. INSTALL REAR SEATBACK BOARD SUB-ASSEMBLY RH
Click here
7. INSTALL REAR SEATBACK LOCK CONTROL BEZEL
Click here
8. INSTALL REAR SEAT SHOULDER BELT HOLE COVER
Click here
9. INSTALL SEAT BELT ANCHOR COVER CAP
Click here
10. INSTALL REAR SEATBACK ASSEMBLY RH
Click here
11. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
Click here
12. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY
Click here
13. INSTALL REAR SEAT HEADREST ASSEMBLY
Click here
Toyota CH-R Service Manual > Smart Key System(for Entry Function): Open in Front Passenger Side Electrical Antenna Circuit (B27A2)
DESCRIPTION
The certification ECU (smart key ECU assembly) generates a request signal and
transmits the signal to the front door outside handle assembly RH (electrical key
antenna) at intervals of 0.25 seconds. For the front door outside handle assembly
RH (electrical key antenna) to detect w ...
Toyota CH-R Service Manual > Spiral Cable: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
spiral cable sub-assembly removal/installation are shown below.
Necessary Procedure After Parts ...