INSTALLATION
PROCEDURE
1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
|
(a) Engage the hook. |
|
(b) Install the rear height control sensor sub-assembly LH with the 2 bolts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
(c) Engage the clamp.
(d) Connect the connector.
2. INSTALL REAR WHEEL (for LH Side)
Click here
3. PERFORM INITIALIZATION
Click here
4. INSPECT HEADLIGHT AIMING
Click here
Inspection
High Mounted Stop Light AssemblyToyota CH-R Service Manual > Theft Deterrent System: Unlock Warning Switch Circuit
DESCRIPTION
The key unlock warning switch assembly comes on when the ignition key is inserted
into the ignition key cylinder and goes off when the ignition key is removed.
WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING TECHSTREAM (KEY UNLOCK WARNING SW)
(a) Con ...
Toyota CH-R Service Manual > Power Window Regulator Motor(for Rear Door): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Apply MP grease to the sliding and rotating areas of the power window regul ...