Components
COMPONENTS
ILLUSTRATION
*1 |
CENTER STOP LIGHT ASSEMBLY |
*2 |
NO. 2 REAR SPOILER COVER |
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SPOILER ASSEMBLY
Click here
2. REMOVE NO. 2 REAR SPOILER COVER
Click here
3. REMOVE CENTER STOP LIGHT ASSEMBLY
(a) Remove the 2 screws. |
|
(b) Disconnect the connector to remove the center stop light assembly.
Inspection
INSPECTION
PROCEDURE
1. INSPECT CENTER STOP LIGHT ASSEMBLY
(a) Apply battery voltage to the center stop light assembly and check that the light comes on. OK:
If the result is not as specified, replace the center stop light assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL CENTER STOP LIGHT ASSEMBLY
(a) Connect the connector.
(b) Install the center stop light assembly with the 2 screws.
2. INSTALL NO. 2 REAR SPOILER COVER
Click here
3. INSTALL REAR SPOILER ASSEMBLY
Click here
Toyota CH-R Service Manual > Occupant Classification System: System Diagram
SYSTEM DIAGRAM
Communication Table
Transmitting ECU
(Transmitter)
Receiving ECU
Signal
Communication Method
Airbag Sensor Assembly
Occupant Detection ECU
Crash detection signal
Acceleration sign ...
Toyota CH-R Service Manual > Rear Suspension Member: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
rear suspension member sub-assembly removal/installation are shown below.
Necessary Procedures A ...