Toyota CH-R Service Manual: License Plate Light Assembly

Toyota CH-R Service Manual / Lighting (ext) / License Plate Light Assembly

Components

COMPONENTS

ILLUSTRATION

*1

LICENSE PLATE LIGHT ASSEMBLY

-

-

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE BACK DOOR OUTSIDE GARNISH

Click here

2. REMOVE LICENSE PLATE LIGHT ASSEMBLY

(a) Disconnect the connector.

(b) Disengage the claws to remove the license plate light assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT LICENSE PLATE LIGHT ASSEMBLY

(a) Apply battery voltage to the license plate light assembly and check that the light comes on.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 2 (B)

Battery negative (-) → Terminal 1 (E)

License plate light comes on

If the result is not as specified, replace the license plate light assembly.

*a

Component without harness connected

(License Plate Light Assembly)

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL LICENSE PLATE LIGHT ASSEMBLY

(a) Engage the claws to install the license plate light assembly.

(b) Connect the connector.

2. INSTALL BACK DOOR OUTSIDE GARNISH

Click here

    High Mounted Stop Light Assembly
    Components COMPONENTS ILLUSTRATION *1 CENTER STOP LIGHT ASSEMBLY *2 NO. 2 REAR SPOILER COVER Removal REMOVAL PROCEDURE 1. REMOVE REAR ...

    License Plate Light Bulb
    Components COMPONENTS ILLUSTRATION *1 LICENSE PLATE LIGHT BULB *2 NO. 2 BACK DOOR SERVICE HOLE COVER *3 LICENSE PLATE LIG ...

    Other materials:

    Toyota CH-R Service Manual > Pre-collision System: Lost Communication with Gateway Module (U1002)
    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area U1002 Lost Communication with Gateway Module When the ignition switch is ON, a communication error between the forward recognition camera an ...

    Toyota CH-R Service Manual > Pre-collision System: Brake Control Signal Mismatch (C1A69)
    DESCRIPTION The skid control ECU (brake actuator assembly) sends signals to the millimeter wave radar sensor assembly according to the brake control status. If the millimeter wave radar sensor assembly receives a VSC system malfunction signal from the skid control ECU (brake actuator assembly ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0142