DTC CHECK / CLEAR
DTC CHECK
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON, and wait for at least 10 seconds.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Occupant Detection / Trouble Codes.
Body Electrical > Occupant Detection > Trouble Codes(f) Check for DTCs by following the prompts on the Techstream screen.
HINT:
Refer to the Techstream operator's manual for further details.
DTC CLEAR
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON and wait for at least 10 seconds.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Occupant Detection / Trouble Codes.
Body Electrical > Occupant Detection > Clear DTCs(f) Clear the DTCs by following the prompts on the Techstream screen.
HINT:
Refer to the Techstream operator's manual for further details.
Diagnosis System
Fail-safe ChartToyota CH-R Service Manual > Vehicle Stability Control System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
If there are no DTCs output and the problem still occurs, check the suspected
areas for each problem symptom in the order given in the following table and proceed
to the relevant troubleshooting page.
NOTICE:
When replacing the skid control ECU (brake actuator assembly) ...
Toyota CH-R Service Manual > Power Steering System: Calibration
CALIBRATION
TORQUE SENSOR ZERO POINT CALIBRATION (USING TECHSTREAM)
NOTICE:
Perform torque sensor zero point calibration if any of the following conditions
occur:
The power steering ECU assembly has been replaced.
The electric power steering column sub-assembly has been replaced.
...