Toyota CH-R Service Manual: Fail-safe Chart

• The passenger airbag ON/OFF indicator ("ON" and "OFF") comes on for approximately 4 seconds, then goes off for approximately 2 seconds.
• Approximately 6 seconds after the ignition switch is turned ON, the passenger airbag ON/OFF indicator will indicate "ON" or "OFF" depending on the following conditions.

• ○: Deployable
• X: Not deployable
• *1: The system judges a person of average adult weight or more as an adult. If a smaller adult sits in the front passenger seat, the system may not recognize them as an adult depending on their physique and posture.
• *2: The system may not recognize a child or a child in a child restraint system as a child depending on factors such as the positioning of the child restraint system or the child's physique or posture.
• *3: Does not deploy when the front passenger seat belt is unfastened.

Dtc Check / Clear

DTC CHECK / CLEAR DTC CHECK (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON, and wait for at least 10 seconds. (d) Turn the Techstream ...

Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any part ...

Other materials:

Toyota CH-R Service Manual > Radiator Grille: Removal
REMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (w/o Toyota Safety Sense) Click here 2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Toyota Safety Sense) Click here 3. REMOVE RADIATOR GRILLE (a) Remove the 2 bolts. (b) ...

Toyota CH-R Service Manual > Vacuum Pump: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during vacuum pump assembly removal/installation are shown below. Necessary Procedure After Parts Removed/ ...