PRECAUTION
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
---|---|---|
Ignition Switch off |
LOCK |
Off (Lock) |
Ignition Switch ACC |
ACC |
On (ACC) |
Ignition Switch ON |
ON |
On (IG) |
Engine Start |
START |
On (Start) |
PRECAUTIONS FOR AUTO WIPER SYSTEM (w/ Rain Sensor)
(a) When the ignition switch is ON and the front wiper switch is in the AUTO position, the rain sensor may operate the front wipers if the rain sensor sensing portion of the windshield glass is touched by a hand or if something moist, such as a wet cloth, is brought near. This may lead to injury or damage to the vehicle.
(b) When the ignition switch is ON and the front wiper switch is in the AUTO position, the rain sensor may operate the front wipers if the rain sensor or parts around the rain sensor (windshield glass, rain sensor cover, etc.) are vibrated.
(c) If the windshield glass is coated with a water-repellent coating, the rain sensor may not correctly detect the amount of raindrops that strike the windshield and the auto wiper system may not operate normally.
(d) As the rain sensor is an optical sensor, if sunlight intermittently strikes the windshield glass or the rain sensor sensing portion of the windshield glass is dirty, the auto wiper system may not operate normally.
PRECAUTION FOR WASHER NOZZLE ADJUSTMENT
(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:
(1) The washer nozzle tip is made of resin and may be damaged.
(2) Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.
Click here
(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.
Toyota CH-R Service Manual > Wiper And Washer System: Terminals Of Ecu
TERMINALS OF ECU
CHECK WINDSHIELD WIPER RELAY ASSEMBLY (w/ Rain Sensor)
(a) Disconnect the F56 windshield wiper relay assembly connector.
(1) Measure the voltage and resistance on the wire harness side connector according
to the value(s) in the table below.
Terminal No.
(Symbol ...
Toyota CH-R Service Manual > Occupant Classification System: Front Occupant Classification Sensor LH Circuit Malfunction (B1780)
DESCRIPTION
The front occupant classification sensor LH circuit consists of the occupant
detection ECU and front in weight detection sensor sub-assembly.
DTC B1780 is stored when a malfunction is detected in the front in weight detection
sensor sub-assembly circuit.
DTC No.
...