INSPECTION
PROCEDURE
1. INSPECT FOG LIGHT ASSEMBLY LH (for LED Type)
|
(a) Apply battery voltage to the fog light assembly LH and check that the light comes on. OK:
If the result is not as specified, replace the fog light assembly LH. |
|
2. INSPECT FOG LIGHT ASSEMBLY RH (for LED Type)
|
(a) Apply battery voltage to the fog light assembly RH and check that the light comes on. OK:
If the result is not as specified, replace the fog light assembly RH. |
|
Adjustment
ReassemblyToyota CH-R Service Manual > Blind Spot Monitor System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Toyota CH-R Service Manual > Quarter Garnish: Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE QUARTER GARNISH MOULDING
(a) Remove the quarter garnish moulding.
...