Toyota CH-R Service Manual: Reassembly

HINT:

• Use the same procedure for the LH and RH sides.
• The procedure described below is for the LH side.

Inspection

INSPECTION PROCEDURE 1. INSPECT FOG LIGHT ASSEMBLY LH (for LED Type) (a) Apply battery voltage to the fog light assembly LH and check that the light comes on. OK: ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FOG LIGHT ASSEMBL ...

Other materials:

Toyota CH-R Service Manual > Blind Spot Monitor System: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor RH (Slave). HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completin ...

Toyota CH-R Service Manual > Electric Parking Brake System: Parts Location
PARTS LOCATION ILLUSTRATION *1 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) *2 ECM *3 NO. 1 ENGINE ROOM RELAY BLOCK - ABS-MAIN FUSE - ECU-IG1 NO. 2 FUSE - - ILLUSTRATION *1 ...