PROBLEM SYMPTOMS TABLE
HINT:
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
System does not operate at all |
Proceed to "Power Source Circuit" |
|
|
CAN communication system |
|
|
|
Blind spot monitor sensor LH (Master) |
|
|
|
System cannot be turned off |
CAN communication system |
|
|
Blind spot monitor sensor LH (Master) |
|
|
|
"Blind Spot Monitor Unavailable" or "Blind Spot Monitor System Malfunction Visit Your Dealer" is displayed on the multi-information display |
Check abnormality history |
|
|
Blind spot monitor sensor RH (Slave) |
|
|
|
Blind spot monitor sensor LH (Master) |
|
|
|
Combination meter assembly |
|
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Outer rear view mirror indicator RH does not illuminate |
Proceed to "Blind Spot Monitor Beam Axis Confirmation" |
|
|
Outer mirror RH |
|
|
|
Outer rear view mirror assembly RH |
|
|
|
Blind spot monitor sensor RH (Slave) |
|
|
|
Outer rear view mirror indicator LH does not illuminate |
Proceed to "Blind Spot Monitor Beam Axis Confirmation" |
|
|
Outer mirror LH |
|
|
|
Outer rear view mirror assembly LH |
|
|
|
Blind spot monitor sensor LH (Master) |
|
|
|
Outer rear view mirror indicator RH remains illuminated |
Proceed to "Blind Spot Monitor Beam Axis Confirmation" |
|
|
Blind spot monitor sensor RH (Slave) |
|
|
|
Outer rear view mirror indicator LH remains illuminated |
Proceed to "Blind Spot Monitor Beam Axis Confirmation" |
|
|
Blind spot monitor sensor LH (Master) |
|
|
|
Outer rear view mirror indicator RH does not flash |
Proceed to "Turn Signal Light" in Problem Symptoms Table for the Lighting (EXT) section |
|
|
Blind spot monitor sensor RH (Slave) |
|
|
|
Outer rear view mirror indicator LH does not flash |
Proceed to "Turn Signal Light" in Problem Symptoms Table for the Lighting (EXT) section |
|
|
Blind spot monitor sensor LH (Master) |
|
|
|
Outer rear view mirror indicator RH continues to flash |
Blind spot monitor sensor RH (Slave) |
|
|
Outer rear view mirror indicator LH continues to flash |
Blind spot monitor sensor LH (Master) |
|
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Function does not operate at all (Blind spot monitor function operates normally) |
Data List / Active Test (Reverse) |
|
|
Continuously Variable Transaxle System (for K114) |
|
|
|
Blind spot monitor sensor RH (Slave) |
|
Customize Parameters
Diagnosis SystemToyota CH-R Service Manual > Rear Door Outside Moulding: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE
1. INSTALL REAR DOOR OUTSIDE MOULDING
(a) Remove the peeling paper from the face of the outside moulding retainer.
HINT:
Aft ...
Toyota CH-R Owners Manual > Engine compartment: Engine oil
With the engine at operating temperature and turned off, check the oil level
on the dipstick.
■ Checking the engine oil
1. Park the vehicle on level ground. After warming up the engine and turning
it off, wait more than 5 minutes for the oil to drain back into the bottom of the
engine.
2. ...